Tuesday, May 24, 2016

C1 Solution for C1-01Not Charging Problem


Here's the solution for C1-01 Not Charging problem like there is No Charging indiion shows on the display when the battery charger is being plug-in.
This problem is may caused by a charger or a components on c1-01 PCB board. This problem may sometimes happens if the device suffered wet or water damaged or just exist.

The solution below will show us the loion of the particular components that needs to be check or by then replace if found damaged.


C1-01 Not Charging Solution-Charger No response
Repair Hints For C1-01 Not Charging:
Check the charging pin connector, ensure that it is cln free from oxidation build up and the terminals were not bended and misaligned.
Cln also the charging pin contact pads on the PCB board.
Check the fuse if it is open or alrdy blown out. A damaged fuse indies that there is a shorted circuit or components happens on the PCB board. Check the chip diode if shorted, and then replace it.

No comments:

Post a Comment